This section describes how to set parameters of a specified disk array.
After storage array parameters settings, parameters of the VLUNs from the storage array will be automatically configured. Aggregation VLUNs do not be automatically configured. In the mean time, after storage array parameters settings, you can configure parameters for a VLUN from the storage array. However, subsequent storage array parameters settings will not apply to the VLUN.
Parameter |
Description |
Value |
|---|---|---|
Load Balancing Mode |
Load balancing mode of UltraPath for Windows. The value is either Within controller or Between controllers. |
[Default value] Within controller [Example] Within controller |
Load Balancing Algorithm |
Load balancing algorithm of UltraPath for Windows. The value can be Minimum queue depth, Minimum task, or Round robin. |
[Default value] Minimal queue depth [Example] Minimal queue depth |
Number of consecutive I/Os for load balancing. The value ranges from 1 to 10,000. |
[Default value] 1 [Example] 1 |
|
LUN Trespass |
Enabling or disabling LUN switchover. The value can be either Enable or Disable. |
[Default value] Disable [Example] Disable |
I/O Suspension Time |
I/O suspension time. The value ranges from 0 to 2,592,000, expressed in seconds. |
[Default value] 60 [Example] 60 |
Max I/O Retry Timeout |
Maximum I/O timeout period of a virtual LUN. The value ranges from 1 to 2,592,000, expressed in seconds. |
[Default value] 1800 [Example] 1800 |