Setting Disk Array Parameters

This section describes how to set parameters of a specified disk array.

Precaution

After storage array parameters settings, parameters of the VLUNs from the storage array will be automatically configured. Aggregation VLUNs do not be automatically configured. In the mean time, after storage array parameters settings, you can configure parameters for a VLUN from the storage array. However, subsequent storage array parameters settings will not apply to the VLUN.

Procedure

  1. In the navigation tree of the UltraPath Console, choose Host > Disk array.
  2. Select the disk array that you want to set.
  3. In the right function pane, click Settings.
    The Disk Array Parameter Settings dialog box is displayed.
  4. In the Disk Array Parameter Settings dialog box, set parameters for the disk array managed by UltraPath for Windows. The following table describes the parameters:

    Parameter

    Description

    Value

    Load Balancing Mode

    Load balancing mode of UltraPath for Windows.

    The value is either Within controller or Between controllers.

    [Default value]

    Within controller

    [Example]

    Within controller

    Load Balancing Algorithm

    Load balancing algorithm of UltraPath for Windows.

    The value can be Minimum queue depth, Minimum task, or Round robin.

    [Default value]

    Minimal queue depth

    [Example]

    Minimal queue depth

    Number of consecutive I/Os for load balancing.

    The value ranges from 1 to 10,000.

    [Default value]

    1

    [Example]

    1

    LUN Trespass

    Enabling or disabling LUN switchover.

    The value can be either Enable or Disable.

    [Default value]

    Disable

    [Example]

    Disable

    I/O Suspension Time

    I/O suspension time.

    The value ranges from 0 to 2,592,000, expressed in seconds.

    [Default value]

    60

    [Example]

    60

    Max I/O Retry Timeout

    Maximum I/O timeout period of a virtual LUN.

    The value ranges from 1 to 2,592,000, expressed in seconds.

    [Default value]

    1800

    [Example]

    1800

  5. Click OK.